Revenge From Mars Weldments

Like Attack from Mars and Monster Bash the weldment gets tore up pretty bad.  The original factory weldment is zinc plated steel.  I use stainless steel for my replacments for the most part and this offers a better finish and a better strength.  My design also includes slots instead of holes so there is some adjustment that can be done.   Email us to order or for more information.

rfm1.jpg (221440 bytes) RFM weldments come with 2 holders for the coil mechanism.  Here is a picture of two. 
rfm2.jpg (120157 bytes) The stainless steel and welds are very bright you can easily see fingerprints.  A few seconds with a scouring pad in the direction of the grain and it looks perfect.
rfm4.jpg (127430 bytes) You can see the slots here as well as the clean welds.
rfm5.jpg (115014 bytes) The finish and mounting holes of the original on the left and the reproduction on the right.  The slotted holes allow you to dial in where the ball ends up.
rfm7.jpg (252201 bytes) Original on the left complete with replacement on the right.